USA Fluid Technologies 519 Seale Kingsville, TX 78363 Email Us
Industrial
Products

MATERIAL SAFETY DATA SHEET

MANUFACTURER

Integrity Industries, Inc.

2710 E. Corral

Kingsville, Texas 78363

Emergency Phone: (512)595-5561

THIS DOCUMENT IS PREPARED PURSUANT TO THE OSHA HAZARDOUS COMMUNICATION STANDARD (29 CFR 1910.1200). ALSO, OTHER SUBSTANCES NOT DEEMED "HAZARDOUS" PER THIS MSDS MAY BE LISTED.

MATERIAL IDENTIFICATION

Trade name: R200T RUST-X

Synonyms/Other Designations: None

Chemical Formula: Proprietary mixture

Hazard(s): Contains mineral acids


PHYSICAL & CHEMICAL DATA

Boiling Poing: 220F

Freezing Point: N/A

Specific Gravity (H2O=1): 1.08

Vapor Pressure (mmHg): N/A

Vapor Density (Air=1): N/A

Solubility in H2O: Dispersible

Appearance: Light Blue opaque liquid

Odor: Bland


SECTION IV - REACTIVITY

Stability: Stable under normal conditions

Incompatibility: Strong bases

Decomposition Products: N/A

Hazardous Polymerizations: Will not occur


SECTION V - FIRE & EXPLOSION DATA

Flash Point: 210F (TCC)

Extinguishing Media: Water, CO2, dry chemical

Special Fire Fighting Procedures: Firefighters should wear a self-contained breathing apparatus as in all chemical fires.

Unusual Fire Hazards: None

pH: 0.5


SECTION VI - EMERGENCY & FIRST AID DATA

Inhalation: Remove to fresh air. If irritation persists, seek medical attention.

Eye Contact: Flush with water for 15 minutes. If irritation persists, seek medical attention.

Skin Contact: Flush with water. Remove contaminated clothing and wash before use. If irritation of skin persists, seek medical attention.

Ingestion: INDUCE VOMITING. Seek medical attention immediately.

 

SECTION VII - HEALTH HAZARDS DATA

Acute:
Respiratory: headache & dizziness
Skin iritation:
Ingestion: mucosal/gastric distress
Eye: irritation

Chronic: None known

 

SECTION VIII - SPILL & DISPOSAL DATA

Accidental Spill Procedures: Spilled material may be absorbed in chalk dust/lime (CaCO3). The material should then be disposed of according to local/state/federal regulations.

Handling & Storage: Store away from alkali. Product discolors concrete.

 

SECTION IX - SPECIAL PROTECTION DATA

Respiratory Protection: Required in confined spaces

Ventilation: General

Exhaust: Local, mechanical

Protective Gloves: Rubber

Eye Protection: Chemical goggles

Other Protection: Rubber aprons, rubber boots

 

SECTION X - TRANSPORT INFORMATION

The following may not apply to all shipping situations. Consult 49CFR for more mode-specific/quantity-specific data.

DOT Proper Shipping Name: Corrosive liquids, n.o.s.

DOT Hazard Class or Division: 8

DOT Identification Number: UN 1760

DOT Packaging Group: III

Type Lbl(s) Required or Exemption Number: Corrosive*
*For limited Quantity Packaging, see DOT 49 CFR part 173.

 

SECTION XI - DISCLAIMERS

SOME INFORMATION PROVIDED HEREIN WAS DRAWN FROM SOURCES OTHER THAN INTEGRITY INDUSTRIES.

THE INFORMATION PROVIDED HEREIN IS BELIEVED BY INTEGRITY INDUSTRIES, INC. TO BE CORRECT & RELIABLE; NO EXPRESSED OR IMPLIED WARRANTY IS PROVIDED, HOWEVER.

INTEGRITY INDUSTRIES, INC. ASSUMES NO RESPONSIBILITY AND DENIES ALL LIABILITY FOR ANY LOSS, DAMAGE OR EXPENSE CONNECTED WITH CUSTOMERS' METHOD OF HANDLING, STORAGE, USE, AND DISPOSAL OF THIS PRODUCT.

THE MSDS INFORMATION PROVIDED HEREIN IS APPLICABLE ONLY TO THIS PRODUCT.